# D1 Mini (ESP8266) not enough voltage to power 4.8V servo

**URL:** <https://forum.core-electronics.com.au/t/d1-mini-esp8266-not-enough-voltage-to-power-4-8v-servo/12503>\
**Category:** Uncategorized\
**Created:** [17 December 2021 06:20 UTC](https://forum.core-electronics.com.au/t/d1-mini-esp8266-not-enough-voltage-to-power-4-8v-servo/12503 "2021-12-17T06:20:27Z")\
**Posts on this page:** 1\
**Showing post:** 7

<div class="post-metadata">

**Author:** ![Oliver33](https://avatars.discourse-cdn.com/v4/letter/o/a9adbd/32.png) [@Oliver33](https://forum.core-electronics.com.au/u/Oliver33)\
**Post date:** [19 December 2021 20:01 UTC](https://forum.core-electronics.com.au/t/d1-mini-esp8266-not-enough-voltage-to-power-4-8v-servo/12503/7 "2021-12-19T20:01:46Z")

</div>

Hey @Tim122099,

~~That battery shield you bought has a major bug - don’t solder that current jumper, and don’t use it with anything less than a 1000mAh lipo. Preferably, don’t use it at all without checking the design.~~

They might’ve just forgotten to update the Charge IC on the schematic…

See my post about that battery shield here:

> [@Polymer Lithium Ion Battery - 400mAh (CE04375)](https://forum.core-electronics.com.au/t/polymer-lithium-ion-battery-400mah-ce04375/298/18):
>
> Hey Tim, That battery shield you linked looks like it has a solderable jumper to set the charge current, but it’s only 500mA or 1000mA: (EDIT: Read to the end! This might be incorrect!) [image] The way these jumpers work is usually by setting the voltage on a pin with a resistor divider. If you’ve got one of these shields already, you could lookup the datasheet for the charge IC and swap out the resistors for a higher value which will set the charge current you need. It’s much easier (but le…

---

_[View the full topic](https://forum.core-electronics.com.au/t/d1-mini-esp8266-not-enough-voltage-to-power-4-8v-servo/12503)._
