Pimoroni Enviro + PiicoDev Adapter

[Trent5487676]

Hi Jono,

@Jono

I’ll need to solder a 3-pin header for the jumper setting right?

Not quite Michael has designed many of the PiicoDev modules so that you can cut a link, or bridge two solder pads to change the address or disable some components.

This address is set according to this connection of solder pads.

I’ve also linked Michael’s explainer below.

PiicoDev MPU-6050 motion sensor - error

I regret not checking the forums over the weekend! There is a less destructive way to disable the Power LED - Cut the jumper labelled PWR LED on the rear side of the board: [image] A hobby knife or razor works well. Be careful not to cut anywhere outside the pill-shaped outline. You can solder across this jumper to re-enable the power LED later. I’ll update product listings to ensure this feature is more obvious.